SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (ENGINE CONTROLS SELF-DIAGNOSTICS)DIAGNOSTIC TESTSDTC P0325: KNOCK SENSOR MODULE CIRCUITDIAGNOSTIC PROCEDURES
2004 Oldsmobile Bravada RWD

Diagnostic Procedures

2004 Oldsmobile Bravada RWDSECTION Diagnostic Procedures
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Observe the Freeze Frame/Failure Records data for this DTC. Turn ignition off for 30 seconds. Start engine. Operate the vehicle within the Conditions for Running DTC or as close as possible to the Freeze Frame/Failure Records data that you observed. See CONDITIONS FOR RUNNING DTC . Did the DTC fail this ignition cycle? If yes, go to next step. If no, see INTERMITTENTS in TROUBLE SHOOTING - NO CODES - 3.4L AZTEK & RENDEZVOUS article.
  3. Replace PCM. See REMOVAL & INSTALLATION - AZTEC & RENDEZVOUS article. Reprogram PCM. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After repairs, go to next step.
  4. Clear the DTCs with a scan tool. Turn ignition off for 30 seconds. Start engine. Operate vehicle within the Conditions for Running DTC. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step  2.
  5. Observe the stored information, Capture Info with a scan tool. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.