Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 373 (AUTOMATIC TRANSMISSION SERVICING)REMOVAL & INSTALLATIONTRANSMISSION SUPPORTINSTALLATION
2004 Oldsmobile Bravada RWD
Transmission Support: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission support to the frame.
- Install the upper transmission support-to-frame mounting bolts. See Figure . Tighten the upper transmission support-to-frame mounting bolts to specification. See TORQUE SPECIFICATIONS .
- Install the lower transmission support-to-frame mounting bolts. See Figure . Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
- Lower the transmission onto the transmission support.
- Install the transmission mount-to-transmission support retaining nuts. See Figure . Tighten the transmission mount-to-transmission support retaining nuts to specification. See TORQUE SPECIFICATIONS .
- Install the EVAP canister.
- Install the fuel tank shield.
- Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.