Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 37 (FRONT SUSPENSION SYSTEM)REMOVAL & INSTALLATIONSTRUT ASSEMBLYREMOVAL
2004 Oldsmobile Bravada RWD
Strut Assembly: Removal
2004 Oldsmobile Bravada RWDSECTION Removal
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Remove nuts securing upper strut to body mount (DO NOT remove nut on end of strut rod).
- Raise and support vehicle, allowing suspension to hang freely. Remove wheel. Disconnect ABS wheel speed sensor connector. Remove brakeline bracket from strut. Mark strut in relation to steering knuckle (if reusing strut). Remove strut bolts, and remove strut.
WARNING:
Do not remove nut from top of strut rod unless coil spring has been compressed. Coil spring is under extreme pressure. If nut is removed without first compressing spring, coil spring will violently decompress, possibly resulting in severe injury.
CAUTION:
After separating strut from steering knuckle, support steering knuckle in upright position to prevent damage to components. Do not overextend axle shaft CV joints. Do not chip or crack coil spring coating. Coil spring may fail if coating is damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.