Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 367 (AUTOMATIC TRANSMISSION SERVICING)REMOVAL & INSTALLATIONVEHICLE SPEED SENSORINSTALLATION
2004 Oldsmobile Bravada RWD
Vehicle Speed Sensor: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the speed sensor and NEW "O" ring seal. See Figure.
- Coat the "O" ring seal (3) with clean transmission fluid.
- Install the vehicle speed sensor (1) into the transmission case.
- Install and tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- Install the harness connector.
- Remove the drain pan.
- Lower the vehicle.
- Fill transmission with appropriate fluid to proper level. See LUBRICATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.