Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 35 (FRONT SUSPENSION SYSTEM)TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Torque Specifications
2004 Oldsmobile Bravada RWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||||
|---|---|---|---|---|---|---|
| Axle Shaft Nut | 118 (160) | |||||
| Ball Joint-To-Control Arm Nut | 117 (158) | |||||
| Ball Joint-To-Knuckle Nut | (1) 41 (55) | |||||
| Control Arm-To-Frame Bolt/Nut (2) | ||||||
| Front | 117 (158) | |||||
| Rear | 117 (158) | |||||
| Exhaust Pipe-To-Manifold Nut | 30 (41) | |||||
| Hub & Bearing Retaining Bolt | 70 (95) | |||||
| Stabilizer Bar Bracket Bolt | 35 (47) | |||||
| Stabilizer Bar Link Nut | 13 (17) | |||||
| Strut-To-Body Nut | 35 (47) | |||||
| Strut-To-Knuckle Bolt | 136 (185) | |||||
| Strut Mount Nut | 55 (75) | |||||
| Tie Rod End-To-Knuckle Nut | (1) 55 (75) | |||||
| Step 1 | 22 (30) | |||||
| Step 2 | Tighten Additional 180 degrees | |||||
| Wheel Lug Nut | 100 (136) | |||||
|
||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.