Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 301 (ELECTRICAL COMPONENT LOCATOR)SPLICES
2004 Oldsmobile Bravada RWD
Section 301 (Electrical Component Locator): Splices
2004 Oldsmobile Bravada RWDSECTION Splices
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
SPLICES LOCATION
| Component | Location |
|---|---|
| SP100 | In engine main harness, located on underside of underhood fuse block. |
| SP107 | In engine accessory harness, near PCM. |
| SP108 | In engine accessory harness, near PCM. |
| SP200 | Behind right body hinge pillar trim panel. |
| SP300 | In floor harness, at right rear of vehicle. |
| SP302 | In floor harness, at left rear of vehicle. |
| SP400 | In back door No. 2 harness, behind liftgate trim panel. |
| S100 (1.8L VIN L) | In engine harness, located on underside of underhood fuse block. |
| S100 (1.8L VIN 8) | In engine harness, located on underside of underhood fuse block. |
| S101 (1.8L VIN L) | In engine harness, near washer pump. See Figure . |
| S101 (1.8L VIN 8) | In engine harness, near washer pump. |
| S103 (1.8L VIN L) | At left rear of engine compartment, near brake pressure modulator valve. See Figure . |
| S103 (1.8L VIN 8) | At right front of engine compartment, near brake pressure modulator valve. |
| S104 | In engine accessory harness, located near noise filter. See Figure . |
| S105 (1.8L VIN L) | In engine accessory harness, near ignition coils. See Figure . |
| S105 (1.8L VIN 8) | In engine accessory harness, near ignition coils. |
| S106 (1.8L VIN L) | In engine accessory harness, near PCM. See Figure . |
| S106 (1.8L VIN 8) | In engine accessory harness, near PCM. |
| S107 | In engine accessory harness, near PCM. |
| S200 | In I/P harness, near A/C power receptical. |
| S201 | In I/P harness, near A/C power receptical. |
| S202 | In I/P harness, near A/C power receptical. See Figure . |
| S500 | In left front door harness. See Figure . |
| S501 | In left front door harness, near master power window switch. |
| S600 | In right front door harness, near power window switch. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.