Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 301 (ELECTRICAL COMPONENT LOCATOR)GROUNDS
2004 Oldsmobile Bravada RWD
Section 301 (Electrical Component Locator): Grounds
2004 Oldsmobile Bravada RWDSECTION Grounds
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
GROUNDS LOCATION
| Component | Location |
|---|---|
| G100 | Near underhood fuse block. |
| G102 (1.8L VIN L) | On right inner fender. See Figure . |
| G102 (1.8L VIN 8) | On right inner fender. See Figure . |
| G103 (1.8L VIN L) | At left front strut tower. See Figure . |
| G103 (1.8L VIN 8) | At left front strut tower. See Figure . |
| G104 (1.8L VIN L) | On left side of cylinder head. See Figure . |
| G104 (1.8L VIN 8) | On left side of cylinder head. See Figure . |
| G105 (1.8L VIN L) | On left side of cylinder head. See Figure . |
| G105 (1.8L VIN 8) | On left side of cylinder head. See Figure . |
| G106 (1.8L VIN 8) | At left rear of cylinder head. See Figure . |
| G106 (1.8L VIN L) | Below throttle body, on underside of intake manifold. |
| G200 | Under left side of dash. See Figure . |
| G201 | Behind right body hinge pillar trim panel. See Figure . |
| G202 | Under left side of dash. See Figure . |
| G300 | Left rear of vehicle, behind upper trim panel. See Figure . |
| G301 | At right rear of vehicle. See Figure . |
| G302 | Left rear of vehicle, behind upper trim panel. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.