Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 3 (WHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURES)JACKING & HOISTING
2004 Oldsmobile Bravada RWD
Jacking & Hoisting
2004 Oldsmobile Bravada RWDSECTION Jacking & Hoisting
WARNING: This page does not describe the selected car, but rather 64 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Envoy is equipped with Automatic Level Control (ALC) on the rear suspension. When lifting vehicle on a hoist, it is important that rear axle trim height remains at normal height at all times to prevent damage to auto level control air compressor. If possible, use a hoist that supports rear tires. If a frame contact hoist must be used, support rear axle with 2 additional jack stands.
Put floor jack or vehicle hoist under vehicle at proper lifting points. See Fig 1 - Fig 7 . If raising vehicle on a twin post hoist, do not damage suspension components, rear axle cover, or steering linkage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.