Control Units

2004 Oldsmobile Bravada RWDSECTION Control Units
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
CONTROL UNITS LOCATION

Component Location
Blower Motor Control Processor Behind right side of dash. See Figure .
Body Control Module Mounted on toe board, in right footwell.
BOSE Signal Processor Under left side of dash, above accelerator pedal.
Driver Door Module In lower center of respective door.
Driver Seat Control Module On underside of driver's seat. See Figure .
Electronic Brake Control Module At left front side of engine compartment, on frame rail.
Electronic Suspension Control (ESC) Module In rear compartment, inside left storage compartment. See Figure .
Headlamp Door Control Module In lower right front of engine compartment. See Figure .
HVAC Control Module Center of dash, under radio.
Ignition Coil Module (8) On valve covers, at top of respective cylinders. See Figure .
Inflatable Restraint Instrument Panel Module At right side of dash.
Inflatable Restraint Sensing & Diagnostic Module Below center of dash, under HVAC control head. See Figure .
Passenger Door Module Bottom center of door, rear of speaker.
Powertrain Control Module (PCM) Behind right front fender, between wheelhouse & dash panel. See Figure .
Radio Antenna Module (Coupe) Behind lower "B" pillar trim panel.
Remote Control Door Lock Receiver On left side of rear compartment.
Throttle Actuator Control Module On PCM, below battery.
Vacuum Control Assembly On right side of HVAC unit, right of blower motor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.