Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 297 (ELECTRICAL COMPONENT LOCATOR)MOTORS
2004 Oldsmobile Bravada RWD
Section 297 (Electrical Component Locator): Motors
2004 Oldsmobile Bravada RWDSECTION Motors
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
MOTORS LOCATION
| Component | Location |
|---|---|
| Air Temperature Actuator (Left) | Left side of HVAC module. |
| Air Temperature Actuator (Right) | Right side of HVAC module. |
| Blower Motor | Behind right side of dash, in HVAC module. See Figure . |
| Cooling Fan Motor (Left) | On left side of radiator. |
| Cooling Fan Motor (Right) | On right side of radiator. |
| Fuel Pump & Sender Assembly | In fuel tank. |
| Idle Air Control (IAC) Valve (3.1L VIN J) | On throttle body assembly. See Figure . |
| Idle Air Control (IAC) Valve (3.8L VIN K) | On throttle body assembly. See Figure . |
| Idle Air Control (IAC) Valve (3.8L VIN 1) | On throttle body assembly. See Figure . |
| Sun Roof Motor | Center rear of sun roof module. |
| Windshield Washer Fluid Pump | On right front corner of engine compartment, in washer fluid reservoir. |
| Windshield Wiper Motor | On left side of firewall, below air inlet screen. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.