Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 294 (ELECTRICAL COMPONENT LOCATOR)MOTORS
2004 Oldsmobile Bravada RWD
Section 294 (Electrical Component Locator): Motors
2004 Oldsmobile Bravada RWDSECTION Motors
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
MOTORS LOCATION
| Component | Location |
|---|---|
| Air Temperature Actuator (Left) | On left end of HVAC assembly. See Figure . |
| Air Temperature Actuator (Right) | On right end of HVAC assembly. |
| Automatic Level Control Compressor | Under left side of vehicle, below driver's door. |
| Blower Motor | Part of HVAC module, behind glove box. |
| Cooling Fan (Left) | Mounted to rear left side of radiator. |
| Cooling Fan (Right) | Mounted to rear right side of radiator. |
| Fuel Pump & Sender Assembly | In fuel tank. |
| Idle Air Control Valve | On throttle body. |
| Mode Actuator | On left end of HVAC assembly. See Figure . |
| Recirculation Actuator | On right end of HVAC assembly. See Figure . |
| Secondary Air Injection (AIR) Pump | At left front of vehicle, below horn. See Figure . |
| Windshield Washer Fluid Pump | On front washer solvent container. |
| Windshield Wiper Motor | At right rear of engine compartment. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.