Section 292 (Electrical Component Locator): Grounds

2004 Oldsmobile Bravada RWDSECTION Grounds
WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
GROUNDS LOCATION

Component Location
G100 On lower left side of engine, near transmission connector. See Figure .
G101 On lower front side of engine, on generator bracket.
G102 On lower left side of engine, near transmission connector. See Figure .
G103 On right side of engine compartment, mounted in front of underhood fuse block.
G104 On lower left side of engine, near transmission connector. See Figure .
G105 At rear of engine, below engine coolant temperature sensor. See Figure .
G106 On left side of engine compartment, near left strut tower, mounted on frame rail.
G107 On right side of engine compartment, mounted in front of underhood fuse block, on frame rail.
G200 In lower left front corner of passenger compartment, on left front windshield pillar.
G201 In lower right corner of passenger compartment, on right front windshield pillar.
G300 Near right body harness, under right front seat, on forward crossmember. See Figure .
G301 Under right front seat, on forward crossmember.
G302 Under left side of rear seat cushion. See Figure .
G303 Under right front seat, on forward crossmember. See Figure .
G305 Under right side of rear seat cushion, near battery.
G310 Behind left rear quarter upper trim panel.
G401 In lower right corner of rear compartment, near taillamp pass-through.
G402 In lower left corner of rear compartment, near taillamp pass-through.
G404 Behind left rear quarter upper trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.