Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 281 (WIPER SYSTEM AND WASHER SYSTEM)SYSTEM TESTSTEST C: WASHERS INOPERATIVE
2004 Oldsmobile Bravada RWD
Test C: Washers Inoperative
2004 Oldsmobile Bravada RWDSECTION Test C: Washers Inoperative
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- If wiper/washer system description and operation has been reviewed and preliminary inspection has been performed, go to next step. If wiper/washer system description and operation has not been reviewed and preliminary inspection has not been performed, go to DESCRIPTION & OPERATION and DIAGNOSTIC STARTING POINT under TROUBLESHOOTING.
- Turn ignition switch to ON position. Activate windshield washer. Does the system operate normally? If so, condition is intermittent. See INTERMITTENTS under TROUBLESHOOTING. If not, go to next step.
- Turn the ignition OFF. Disconnect the inline harness connector C201 (I/P wiring-to-steering column connector - 48 pins). See Figure . Remove the connector terminal row E from the steering column harness connector. Connect the inline harness connector C201. Turn the ignition ON. Are the windshield washers always on? If so, go to next step. If not, go to step 5 .
- Repair the windshield washer pump control circuit for a short to voltage. After repairs are complete, go to step 7 .
- Inspect for poor connections at the windshield wiper/washer switch. Did you find and correct the condition? If so, go to step 7 . If not, go to next step.
- Replace the windshield wiper/washer switch. See WIPER/WASHER SWITCH under REMOVAL & INSTALLATION. After repairs are complete, go to step 7 .
- Operate system to verify fault no longer exists. If fault still exists, go to step 3 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.