Wiper Motor Assembly: Installation

2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the water shield and shaft seal onto the wiper motor.
  2. Position the wiper motor to the wiper drive system module.
  3. Install the wiper motor screws. Tighten the screws to 62 INCH lbs. (7 N.m).
  4. Install the wiper drive system module.
  5. Install the wiper motor crank arm.
  6. Install the air inlet grille panel.
  7. Install air inlet screen assembly. Install wiper arm assemblies. See WIPER ARMS  . Check wipers for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.