Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fill Valve-To-Union Fill Line: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Sunfire and 2003 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Install the fill line at the union with a new "O" ring face seal. Lubricate the "O" ring with petroleum jelly or equivalent. Tighten the fill line fitting to specification. See TORQUE SPECIFICATIONS .
- Install the fill line (3) at the fill valve (5) with a new "O" ring face seal. Lubricate the "O" ring with petroleum jelly, or equivalent. Tighten the fill line fitting to specification. See TORQUE SPECIFICATIONS .
- Connect the negative battery cable. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- Connect the HPL power harness connector.
- Start the engine. Check for CNG fuel leaks at each serviced fitting using the Combustible Gas Detector (J 45878), or equivalent.
- Slip the vent boot over the fill valve fitting. Tighten the fill valve boot clamp to specification. See TORQUE SPECIFICATIONS .
- Install the left wheelhouse carpet, the cargo net knobs and the cargo net.
- Install the trunk trim panel.
- Install the fuel tank cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.