Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Tank Pressure Sensor: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install FTP sensor (1) to fuel sender assembly.
- Install FTP sensor retaining clip (2). See Figure .
- Connect fuel sender harness connector (1). See Figure .
- Connect FTP sensor harness connector (2). Inspect the butyl caulk seal for the fuel sender access panel. See Figure .
- Replace any missing butyl caulk as necessary.
- Install access panel to rear seat floor.
- Relocate carpet under the seat and left sill plate area.
- Install sill plate to left side door opening.
- Install rear seat bottom cushion.
- Secure seat cushion using the 2 fasteners.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.