SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 258 (ENGINE CONTROL SYSTEM - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL PUMPREMOVAL
2004 Oldsmobile Bravada RWD

Fuel Pump: Removal

2004 Oldsmobile Bravada RWDSECTION Removal
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The numbers in parenthesis in removal and installation procedures refer to numbered components in referenced figure(s).
  1. Remove the fuel sender assembly. See FUEL SENDER ASSEMBLY  .
  2. Remove the lower cap (9) and the lower cushion (8) from the fuel sender assembly. See Fig 1 .
  3. Remove the fuel pressure regulator (6).
  4. Disconnect the fuel level sensor harness connector.
  5. Remove the fuel level sensor (3).
  6. Remove the fuel sender top cap (2) from the fuel filter assembly.
  7. Disconnect the fuel pump harness connector.
  8. Remove the fuel pump (11) from the fuel filter assembly (13). See Fig 1 .
  9. Remove the locking ring (10) for the fuel strainer from the fuel pump. See Fig 1 .
Fig 1: Exploded View Of Fuel Sender Assembly
G00180641Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.