Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
TCC Pulse Width Modulation Solenoid: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the TCC PWM solenoid (334).
- Install the TCC PWM solenoid retaining clip (314F).
- Connect the TCC PWM solenoid electrical connector.
- Install the oil pump to the valve body. See Figure .
- Install the oil pump bolts (206 and 207) and tighten as follows:
- Bolt No. 207 - 106 INCH lbs. (12 N.m).
- Bolt No. 206 - 12 ft. lbs. (16 N.m).
See Figure .
- Reposition and connect the electrical connectors to the following:
- Fluid pressure manual valve position switch assembly. See Figure .
- 2-3 Shift solenoid valve assembly.
- Install the case side cover. See CASE SIDE COVER .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.