Fastener Tightening Specifications

2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Transfer Case Bracket-to-Engine Bolt - Hole 4 50 N.m 37 lb ft
Transfer Case Bracket-to-Engine Bolts - Holes 1, 2, and 3 23 N.m 17 lb ft
Transfer Case Bracket-to-Transfer Case Bolts - Holes 5 and 6 50 N.m 37 lb ft
Transfer Case Drain Plug 39 N.m 29 lb ft
Transfer Case Fill Plug 39 N.m 29 lb ft
Transfer Case Half Bolts (Qty: 12) 29 N.m 21 lb ft
Transfer Case Heat Shield Bolts (Qty: 3) 11 N.m 97 lb in
Transfer Case Rear Output Drive Gear Nut (Qty: 1) 235 N.m 173 lb ft
Transfer Case Rear Output Drive Shaft Housing Bolts (Qty: 6) 29 N.m 21 lb ft
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.