Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the CKP sensor O-ring with clean engine oil.
- Remove the CKP sensor.
- Remove the CKP sensor stud.
Tighten: Tighten the stud to 10 N.m (89 lb in).
- Connect the engine wiring harness electrical connector (4) to the CKP sensor (3).
- Install the engine wiring harness heat shield (2).
- Install the engine wiring harness heat shield bolts (1 and 4).
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Install the engine wiring harness heat shield nut (3).
Tighten: Tighten the nut to 10 N.m (89 lb in).
- Install the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LZ4) .
- Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.