Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Position the trailing arm bracket to the trailing arm.
- Loosely install the trailing arm bushing to bracket nut and bolt.
- Push upward on the trailing arm bracket and loosely install the front bolt (1).
- Use a drift to align the remaining trailing arm bracket bolts (1). Tighten the bolts to 110 N.m (81 lb ft).
- Tighten the trailing arm bushing to bracket nut and bolt to 160 N.m (118 lb ft).
- Install the park brake cable on the trailing arm and on the frame. Refer to Parking Brake Rear Cable Replacement .
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.