Windshield Wiper Motor Replacement

2004 Oldsmobile Bravada RWDSECTION Windshield Wiper Motor Replacement
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Wiper Motor
GM1877635Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the windshield wiper transmission frame assembly. Refer to Windshield Wiper Transmission Replacement .
1 Windshield Wiper Motor Bolt (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:  8 N.m (71 lb in)

2 Windshield Wiper Motor

Procedure

  1. Using a J 39232  Wiper Linkage Separator or similar tool remove the transmission drive links from the wiper motor crank arm ball stud.
  2. Using a J 39529  Wiper Linkage Installer or similar tool install the wiper transmission drive links onto the wiper motor crank arm ball stud.

Tip:  Apply a small amount of grease to the inner cup on the transmission links to aid in installation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.