Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1956 (ENGINE EXHAUST SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Catalytic Converter to Exhaust Manifold Nut (LZ4/LY7) | 45 N.m | 33 lb ft |
| Exhaust Manifold Bolt (LZ4/LY7) | 20 N.m | 15 lb ft |
| Exhaust Manifold Heat Shield Bolt (LZ4/LY7) | 10 N.m | 89 lb in |
| Exhaust Manifold Lower Heat Shield Bolt | 10 N.m | 89 lb in |
| Exhaust Manifold Lower Heat Shield Bolt | 50 N.m | 37 lb ft |
| Exhaust Pipe to Muffler Nut (LZ4/LY7) | 25 N.m | 18 lb ft |
| Exhaust Pipe to Right Catalytic Converter Nut (LZ4/LY7) | 25 N.m | 18 lb ft |
| Heater Oxygen Sensor (HO2S) | 42 N.m | 31 lb ft |
| Heat Shield Nut | 10 N.m | 89 lb in |
| Intermediate Pipe to Muffler Nut (LAT) | 30 N.m | 22 lb ft |
| Left Catalytic Converter-to-Right Catalytic Converter Nut (LZ4/LY7) | 25 N.m | 18 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.