SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1933 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSINSTRUMENT PANEL RETAINER REPLACEMENT
2004 Oldsmobile Bravada RWD

Instrument Panel Retainer Replacement

2004 Oldsmobile Bravada RWDSECTION Instrument Panel Retainer Replacement
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Instrument Panel Retainer
GM1869905Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: To avoid damage to the vehicle and/or the components of the instrument panel because of hidden fasteners and retainers the instrument panel must be removed from the vehicle as an assembly.

Preliminary Procedures

  1. Remove the instrument panel assembly. Refer to Instrument Panel Assembly Replacement .
  2. Remove the HVAC module assembly. Refer to Air Conditioning and Heater Module Assembly Replacement .
  3. Remove the instrument panel trim panel assembly. Refer to Instrument Panel Trim Panel Replacement .
1 Instrument Panel Retainer Nut (Qty: 4)
CAUTION: Refer to Fastener Caution .

Tighten:  20 N.m (15 lb ft)
2 Instrument Panel Retainer Assembly

Procedure

  1. Note the location and routing of the instrument panel wiring harness to ensure proper reinstallation.
  2. Disconnect the instrument panel wiring harness from the instrument panel retainer.
  3. When replacing the instrument panel retainer assembly, transfer all necessary components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.