Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1844 (FRONT SUSPENSION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Ball Joint to Control Arm Bolt and Nut | 68 N.m | 50 lb ft |
| Brake Bracket Bolt | 15 N.m | 11 lb ft |
| Control Arm to Frame Front Bolt | 200 N.m | 148 lb ft |
| Control Arm to Frame Rear Nuts | 70 N.m | 52 lb ft |
| Lower Control Arm Ball Stud Nut | 40 N.m | 30 lb ft |
| Rear Bushing to Lower Control Arm Nut | 150 N.m | 110 lb ft |
| Stabilizer Bar Clamp Bolt | 50 N.m | 37 lb ft |
| Stabilizer Link Nuts | 65 N.m | 48 lb ft |
| Strut Shaft Nut | 75 N.m | 55 lb ft |
| Strut to Body Nuts and Bolts | 25 N.m | 18 lb ft |
| Strut to Steering Knuckle Bolt and Nut | 180 N.m | 133 lb ft |
| Tie Rod Retention Nut | 60 N.m | 44 lb ft |
| Wheel Bearing/Hub Mounting Bolt | 130 N.m | 96 lb ft |
| Wheel Drive Shaft Spindle Nut | 205 N.m | 157 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.