Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting/Connecting Electrical Connector To Sunroof Control Module
    GM964562Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector to the sunroof control module.
  2. Fig 2: Inserting Control Module Tabs
    GM964601Courtesy of GENERAL MOTORS CORP.
  3. Insert the control module tabs into the sunroof module slots.
  4. Slide the sunroof express module away from the sunroof motor until it is fully engaged.
  5. Verify the proper operation of the sunroof before securing the headliner.
  6. Install the headliner. Refer to Headlining Trim Panel Replacement .
  7. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.