SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1811 (FRAME AND UNDERBODY)REPAIR INSTRUCTIONSASSIST STEP REPLACEMENT (DENALI/ESCALADE)NOTES
2004 Oldsmobile Bravada RWD

Assist Step Replacement (Denali/Escalade): Notes

2004 Oldsmobile Bravada RWDSECTION Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Avalanche, 2003 Cadillac Escalade EXT, and 2003 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.

Removal Procedure 

  1. Remove the push-in retainer from the assist step front cover.
  2. Remove the cover from the vehicle.
    Fig 1: Removing Push-In Retainer From Assist Step Front Cover
    G03384587Courtesy of GENERAL MOTORS CORP.
  3. Remove the retainer clip from the assist step rear cover.
  4. Remover the cover from the vehicle.
    Fig 2: Removing Retainer Clip From Assist Step Rear Cover
    G03384588Courtesy of GENERAL MOTORS CORP.
  5. Remove the bottom fender bolt (2) and the washer (1) from the vehicle.
    Fig 3: Removing Bottom Fender Bolt And Washer From Vehicle
    G03384589Courtesy of GENERAL MOTORS CORP.
  6. With the aid of an assistant, remove the bolts (1, 5) and the nuts (2, 3) from the assist step brackets.
  7. Remove the assist step from the vehicle.
  8. Remove the heater and A/C tubes retaining nuts from the studs, if equipped. Refer to HEATER PIPE REPLACEMENT -- AUXILIARY in Heating, Ventilation, and Air Conditioning.
  9. Remove the assist step bolts (6) from the brackets.
  10. Remove the brackets (4) from the vehicle.
    Fig 4: Removing Assist Step Bolts From Brackets
    G03384590Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.