SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1802 (ENGINE EXHAUST SYSTEM)REPAIR INSTRUCTIONSEXHAUST SYSTEM REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the frame brace. Refer to Frame Brace Replacement (TrailBlazer, Envoy, Bravada) or Frame Brace Replacement (TrailBlazer EXT, Envoy XL) in Frame and Underbody.
  3. Remove the spare tire assembly.
  4. Remove the rear axle tie rod. Refer to Rear Axle Tie Rod Replacement in Rear Suspension.
  5. Remove the rear axle brace. Refer to Rear Axle Brace Replacement in Rear Suspension.
    6. Fig 1: Exhaust Pipe To Muffler Joint
    GM753687Courtesy of GENERAL MOTORS CORP.
  6. Remove the nuts that secure the muffler to the catalytic converter.
    7. Fig 2: Locating Exhaust Hangers
    GM753688Courtesy of GENERAL MOTORS CORP.
  7. Separate the exhaust system from the exhaust hanger insulators.
  8. Remove the exhaust system.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.