SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1787 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSLOWER CONTROL ARM BRACKET REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Lower Control Arm Bracket
    GM792368Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the lower control arm bracket mounting bolts to the frame.

    Tighten: 

    • Tighten the front lower control arm bracket mounting bolt to 265 N.m (195 lb ft).
    • Tighten the rear lower control arm bracket mounting bolts to 240 N.m (177 lb ft).

  3. Install the lower control arm to the lower control arm bracket.
    4. Fig 2: Removing/Installing Lower Control Arm-To-Lower Control Arm Bracket Mounting Nuts
    GM744325Courtesy of GENERAL MOTORS CORP.
  4. Install the lower control arm to lower control arm bracket mounting bolts.
    5. IMPORTANT: Ensure that the lower control arm is parallel to the lower control arm bracket during the installation and tightening of the lower control arm mounting bolts and nuts. This will ensure correct alignment of the lower control arm bushings.
  5. Install the lower control arm to lower control arm bracket mounting nuts.

    Tighten:  Tighten the nuts to 110 N.m (81 lb ft).

    6. Fig 3: View Of Stabilizer Shaft Link Lower Retaining Nut
    GM731562Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.