SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1776 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSTHERMOSTAT REPLACEMENT (4.2L ENGINE)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Thermostat Housing & Bolts
    GM637656Courtesy of GENERAL MOTORS CORP.
  1. Install the thermostat housing to the engine block.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the thermostat housing bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Lubricate the inner diameter of the radiator hose with engine coolant.
    4. Fig 2: Locating Thermostat Housing
    GM753670Courtesy of GENERAL MOTORS CORP.
  4. Install the outlet hose to the thermostat housing (1). Secure the hose with the clamp.
  5. Install the generator. Refer to Generator Replacement (4.2L Engine) or Generator Replacement (5.3L Engine) in Engine Electrical
  6. Fill the cooling system with specified coolant and concentration. Refer to Draining and Filling Cooling System (LL8)  or Draining and Filling Cooling System (LM4) .
  7. Inspect all sealing surfaces for leaks after starting the engine.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.