Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1757 (FRAME AND UNDERBODY)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Assist Step Bracket to Assist Step Nuts | 25 N.m | 18 lb ft |
| Assist Step Bracket to Body Bolts | 25 N.m | 18 lb ft |
| Body Mount Bolts | 80 N.m | 59 lb ft |
| Engine Shield Mounting Bolts | 25 N.m | 18 lb ft |
| Frame Brace Mounting Bolts | 50 N.m | 37 lb ft |
| Front Steering Gear Crossmember Mounting Bolts | 50 N.m | 37 lb ft |
| Fuel Tank Shield to Frame Mounting Bolts | 25 N.m | 18 lb ft |
| Lower Control Arm Bracket Rear Mounting Bolts | 240 N.m | 177 lb ft |
| Lower Transmission Support to Frame Bolts | 50 N.m | 37 lb ft |
| Radiator Support Shield Mounting Bolts | 17 N.m | 13 lb ft |
| Rear Steering Gear Crossmember Mounting Bolts | 50 N.m | 37 lb ft |
| Tow Hook to Front Impact Bar Bolt | 50 N.m | 37 lb ft |
| Transfer Case Shield Mounting Bolts | 16 N.m | 12 lb ft |
| Transmission Mount to Transmission Support Nuts | 46 N.m | 35 lb ft |
| Upper Transmission Support to Frame Bolts | 80 N.m | 59 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.