SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1743 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSSIR DISABLING AND ENABLING ZONE 1ENABLING PROCEDURE
2004 Oldsmobile Bravada RWD

Enabling Procedure

2004 Oldsmobile Bravada RWDSECTION Enabling Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
    2. Fig 1: View Of Connector Position Assurance At Front End Sensor Connectors
    GM842979Courtesy of GENERAL MOTORS CORP.
  2. Connect the EFS connectors to both (2) EFS.
  3. Install the CPAs to both EFS connectors.
  4. Install sensor bracket to bumper. Refer to Inflatable Restraint Front End Sensor Replacement .
  5. Install the grille. Refer to Grille Replacement (Envoy, Envoy XUV) or Grille Replacement (TrailBlazer) or Grille Replacement (Rainier) in Exterior Trim.
    6. Fig 2: View Of Fuse & Relay Block
    GM884366Courtesy of GENERAL MOTORS CORP.
  6. Install the SIR fuse into the fuse block (1) located in the underhood fuse block.
  7. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG indicator will then turn OFF.
  8. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.