Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1739 (INTERIOR TRIM)REPAIR INSTRUCTIONSROOF CONSOLE RETAINER REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Screws Securing Console Retainer To Z Clips

Courtesy of GENERAL MOTORS CORP.

If replacing the roof retainer, install the roof retainer the roof panel ensuring the Z clips are fully seated.
If installing the existing roof retainer, position the roof retainer to the roof panel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Partially install the 4 screws retaining the roof retainer to the Z clips.
Tighten: Tighten the roof retainer attachment screws to 1.2 N.m (10 lb in).
Install the headliner. Refer to Headliner Replacement (Envoy XUV) or Headliner Replacement (TrailBlazer EXT, Envoy XL) or Headliner Replacement (Trailblazer, Envoy, Rainier) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.