Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1739 (INTERIOR TRIM)REPAIR INSTRUCTIONSASSIST HANDLE REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Isuzu Ascender, 2005 GMC Envoy XUV, 2005 GMC Envoy XL, 2005 GMC Envoy, and 2005 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Position the bezels to the headliner.
Rotate the bezels in order to seat the bezel retaining tabs above the headliner.

Fig 1: Removing Handle From Roof Panel

Courtesy of GENERAL MOTORS CORP.

Install the front and rear roof panel tabs into the bezels.

Fig 2: Plastic Retaining Tab And Roof Panel Tab

Courtesy of GENERAL MOTORS CORP.

Ensure the top of the roof panel tab (2) is positioned over the plastic retaining tab (1).

Fig 3: Front Roof Panel Tab

Courtesy of GENERAL MOTORS CORP.

Using a flat bladed tool, carefully push up on the bottom of the front roof panel tab (1) until fully seated.
Using a flat bladed tool, carefully push on the bottom of the rear roof panel tab until fully seated.
Close the bezel covers.
Pull downward on the assist handle to ensure the handle is fully secured to the roof panel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.