SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1714 (ENGINE EXHAUST)REPAIR INSTRUCTIONSINTERMEDIATE PIPE REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
  1. Hoist the vehicle
    2. Fig 1: Mid Muffler
    GM927857Courtesy of GENERAL MOTORS CORP.
  2. Obtain a piece of (non-stretchable) string 18 1/2 inches long. Starting from the muffler, place the string along the pipe. Mark the end of the string on the pipe.
    3. NOTE: Always use a chain cutter to cut the stainless steel pipe. A torch leaves a rough edge and may warp the pipe.
  3. Using the SA9168NE  (or equivalent), cut the pipe on the mark.
    4. Fig 2: View Of Gasket Onto Front Pipe Flange
    GM898156Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear exhaust pipe flange to intermediate pipe nuts.
    5. Fig 3: View Of Hanger From Rubber Isolators
    GM926825Courtesy of GENERAL MOTORS CORP.
  5. Separate the hanger from the rubber isolators.
  6. Remove the resonator and pipe assembly.
  7. Fully remove the gasket material and discard.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.