Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the wiper module electrical connector to the motor.
- Connect the wire harness rosebud clip to the wiper module frame.
- Install the wiper module assembly into the plenum.
- Install the fasteners attaching the wiper module assembly to the plenum.
Tighten: Tighten the fasteners to 12 N.m (9 lb ft)
- Turn the key to RUN position and cycle wiper system to ensure motor is in the park position.
- Install the air inlet screens. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Install the wiper arms. Refer to Wiper Arm Replacement .
NOTE:
Refer to FASTENER NOTICE
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.