Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1687 (ROOF)REPAIR INSTRUCTIONSSUNROOF MODULE ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sunroof Module Assembly

Courtesy of GENERAL MOTORS CORP.

With an assistant, position the new sunroof module assembly into the roof opening.
Install the bolts which secure the sunroof module assembly to the roof and tighten the bolts by hand.
Place a 12 mm (0.47 in) pin into the sunroof module alignment holes.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Remove the alignment pins.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Install the front and rear sunroof drain hoses. Refer to Sunroof Drain Hose Replacement - Front and Sunroof Drain Hose Replacement - Rear .
Connect the electrical connectors to the sunroof module.
Secure the harness to the sunroof module.
Adjust the sunroof window. Refer to Sunroof Window Height and Opening Fit Adjustment .
Verify the proper operation of the sunroof before securing the headliner.
With an assistant, install the headliner. Refer to Headliner Replacement in Interior Trim.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.