Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the water shield and shaft seal onto the wiper motor.
- Position the wiper motor to the wiper drive system module.NOTE: Refer to FASTENER NOTICE .
- Install the wiper motor screws.
Tighten
Tighten the screws to 7 N.m (62 lb in).
- Install the wiper drive system module. Refer to Wiper Drive System Module Replacement .
- Install the wiper motor crank arm. Refer to Wiper Motor Crank Arm Replacement .
- Install the air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.