Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wiper drive system module to the vehicle.
  2. Connect the wiper motor electrical connector.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the wiper drive system screws.

    Tighten 

    Tighten the screws to 10 N.m (89 lb in).

  4. Using the J 39529,  Install the wiper transmission to the wiper motor crank arm.
  5. Install the wiper motor water deflector. Refer to Wiper Motor Water Deflector Replacement .
  6. Install air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT .
  7. Check the wipers for proper operation.
    Fig 1: Wiper Drive System Module
    G01616253Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.