Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Position the washer solvent container to the right frame rail.NOTE: Refer to FASTENER NOTICE .
- Install the washer solvent container bracket screw.
Tighten
Tighten the screw to 10 N.m (89 lb in).
- Connect the washer solvent level sensor electrical connector.
- Connect the washer pump electrical connector.
- Connect the washer pump hose.
- Install the front fender liner. Refer to FRONT FENDER LINER REPLACEMENT .
- Install the washer solvent container screws.
Tighten
Tighten the washer solvent container screws to 10 N.m (89 lb in).
- Install the right headlamp assembly. Refer to HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENT .
- Install the washer solvent container filler neck. Refer to Washer Solvent Container Filler Neck Replacement .
- Fill the washer solvent container with washer solvent.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.