SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1644 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH SUPPORT REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood latch support to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts that retain the hood latch support to the radiator support.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    Fig 1: Removing/Installing Hood Latch Support Retaining Bolts
    GM749967Courtesy of GENERAL MOTORS CORP.
  3. Install the hood latch. Refer to Hood Latch Replacement  .
  4. Install the headlamp housing panel. Refer to Headlamp Housing Panel Replacement (Chevrolet, GMC)  or Headlamp Housing Panel Replacement (Oldsmobile)  .
  5. Install the radiator air intake baffle. Refer to Air Intake Baffle Replacement - Radiator  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.