Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1639 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSHOCK MODULE YOKE REPLACEMENTREMOVAL PROCEDURE

2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
Remove the shock module yoke to lower control arm mounting nut.

Fig 1: Removing/Installing Shock Module Yoke Lower Mounting Nut
Courtesy of GENERAL MOTORS CORP.
Install J 24319-B to the shock module yoke to lower control arm stud.
Disconnect the shock module yoke from the lower control arm using J 24319-B .

Fig 2: Disconnecting Shock Module Yoke From Lower Control Arm
Courtesy of GENERAL MOTORS CORP.
Remove the shock module yoke to shock absorber pinch bolt and nut.

Fig 3: View Of Shock Module Yoke To Shock Absorber Pinch Bolt & Nut
Courtesy of GENERAL MOTORS CORP.
Spread the shock module yoke at the pinch bolt using a flat bladed tool.

Fig 4: Spreading Shock Module Yoke
Courtesy of GENERAL MOTORS CORP.
Remove the shock module yoke from the shock absorber.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.