Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1631 (INTERIOR TRIM)REPAIR INSTRUCTIONSSUNSHADE REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Align the sunshade retainer bezel to the headliner and apply pressure until fully seated.

Fig 1: Aligning Sunshade Retainer Bezel To Headliner

Courtesy of GENERAL MOTORS CORP.

Position the sunshade in the vehicle.
Connect the electrical connector (3), if equipped.

Fig 2: Connecting Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Align the sunshade arm so that the triangular base with the arrow (4) is parallel to the sunshade (3).

Fig 3: Aligning Sunshade Arm Triangular Base With Parallel To Sunshade

Courtesy of GENERAL MOTORS CORP.

Position the sunshade so it is parallel to the door.
Press up until the flange is seated in the retainer bezel. Maintain this pressure.
Quickly rotate the sunshade toward the windshield until it is past the sunshade anchor. A slight click will be heard once the retainer shaft seats into the bezel.
Return the sunshade to its stored position.

Fig 4: Pressing Up Until Flange Is Seated In Retainer Bezel

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.