Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1614 (FRONT SUSPENSION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |||
|---|---|---|---|---|
| Metric | English | |||
| (1)Front Lower Control Arm Ball Stud to Steering Knuckle Nut | 20 N.m + 120 degrees | 15 lb ft + 120 degrees | ||
| Front Lower Control Arm Mounting Nuts | 113 N.m | 83 lb ft | ||
| Front Lower Control Ball Stud Nuts to Control Arm | 68 N.m | 50 lb ft | ||
| Front Stabilizer Shaft Bracket Bolt | 48 N.m | 35 lb ft | ||
| Front Stabilizer Shaft Link Nut | 23 N.m | 17 lb ft | ||
| Front Suspension Strut Mount Nut | 85 N.m | 63 lb ft | ||
| Front Suspension Strut to Body Mount Nuts | 33 N.m | 24 lb ft | ||
| Front Suspension Strut to Steering Knuckle Bolts | 122 N.m | 90 lb ft | ||
| Wheel Bearing/Hub Bolts | 130 N.m | 96 lb ft | ||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.