Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1590 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK LATCH REPLACEMENT-REARINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the seat back latch assembly to the seat frame.
Attach the recliner cables to the folding mechanism.
NOTE: Refer to FASTENER NOTICE .
Install the bolts (1,2) that retain the latch assembly to the seat frame.
Tighten

Tighten the bolts to 45 N.m (33 lb ft).
Install the seat back cover. Refer to Seat Back Cover And Pad Replacement-Rear .
Install the armrest, if equipped. Refer to Armrest Replacement-Rear Seat (60/40 Split) .
Install the rear seat to the vehicle. Refer to Seat Replacement-Rear (Extended Cab W/4Th Door) or Seat Replacement-Rear (Extended Cab) or Seat Replacement-Rear (60/40 Split) .

Fig 1: Rear Seat Back Latch
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.