Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1590 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK FRAME REPLACEMENT-FRONTREMOVAL PROCEDURE

2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Remove the seat from the vehicle. Refer to Seat Replacement-Front Bucket .
Remove the head restraint and guides. Refer to Head Restraint Replacement .
Remove the seat trim panel. Refer to Trim Panel Replacement-Front Seat .
Disconnect the lumbar cable (6) underneath the seat cushion (disconnect the lumbar wire harness if equipped with power lumbar).
Remove the seat back trim cover and pad. Refer to Seat Back Cover And Pad Replacement-Front .
Remove the lumbar assembly (or power lumbar/bolster assembly if equipped). Refer to Lumbar Replacement-Front Seat .
Remove the seat belt retractor. Refer to SEAT BELT RETRACTOR REPLACEMENT-LEFT FRONT or SEAT BELT RETRACTOR REPLACEMENT-RIGHT FRONT .
Remove the inboard pivot bolt (1).

Fig 1: Inboard Pivot Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the recliner arm attachment bolts (2).
Remove the frame from the vehicle.
Transfer all necessary components to the new seat back frame.

Fig 2: Recliner Arm Attachment Bolts
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.