Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Passenger Door Module
Heated Seat Mode: The scan tool displays Off, High, Med, or Low depending on the current heat level operating mode.
Heat Indicator Low: The scan tool displays Active or Inactive. The scan tool displays the current status of the low heat operating mode determined by the heated seat switch signal circuit inputs to the passenger door module.
Heat Indicator Medium: The scan tool displays Active or Inactive. The scan tool displays the current status of the medium heat operating mode determined by the heated seat switch signal circuit inputs to the passenger door module.
Heat Indicator High: The scan tool displays Active or Inactive. The scan tool displays the current status of the high heat operating mode determined by the heated seat switch signal circuit inputs to the passenger door module.
Back Only Heat Indicator: The scan tool displays Active or Inactive. The scan tool displays the current status of the heated seat back only operating mode determined by the heated seat switch signal circuit inputs to the passenger door module.
Back Only Heat Mode: The scan tool displays Active or Inactive. Whenever the heated seat back only operating mode is commanded on by the passenger door module the scan tool displays Active.
Memory Switch: The scan tool displays Memory 1, Memory 2, Exit, or Idle. The scan tool displays the current memory switch status determined by the memory 1 and memory 2 signal circuit inputs to the passenger door module.
Heat Indicator Low: The scan tool displays Active or Inactive. Whenever the low heat indicator is commanded on by the passenger door module the scan tool displays Active.
Heat Indicator Medium: The scan tool displays Active or Inactive. Whenever the medium heat indicator is commanded on by the passenger door module the scan tool displays Active.
Heat Indicator High: The scan tool displays Active or Inactive. Whenever the high heat indicator is commanded on by the passenger door module the scan tool displays Active.
Back Only Heat Indicator: The scan tool displays Active or Inactive. Whenever the heated seat back only indicator is commanded on by the passenger door module the scan tool displays Active.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.