SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1563 (ENGINE COOLING SYSTEM)REPAIR INSTRUCTIONSRADIATOR REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radiator to the vehicle.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the radiator bolts.

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the engine oil cooler lines to the radiator. Refer to Engine Oil Cooler Pipe/Hose Quick Connect Fitting .
  4. Install the transmission oil cooler lines to the radiator. Refer to TRANSMISSION OIL COOLER LINE QUICK CONNECT FITTING or TRANSMISSION OIL COOLER LINE QUICK CONNECT FITTING .
    Fig 1: Install Radiator & Bolts
    G02109261Courtesy of GENERAL MOTORS CORP.
  5. Install the radiator vent inlet hose to the radiator.
  6. Reposition the radiator vent inlet hose clamp to the radiator.
  7. Install the lower fan shroud. Refer to Fan Shroud Replacement - Lower .
  8. Install the outlet hose to the radiator.
  9. Reposition the outlet hose clamp to the radiator.
  10. Install the inlet hose to the radiator.
  11. Reposition the inlet hose clamp to the radiator.
  12. Fill the cooling system. Refer to Draining and Filling Cooling System .
    Fig 2: Install Radiator Vent Inlet
    G02109262Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.