Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1550 (WHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURES)REPAIR INSTRUCTIONSMEASURING WHEEL ALIGNMENT (WITH REAR WHEEL STEERING)LEARN WHEEL ALIGNMENT PROCEDURE
2004 Oldsmobile Bravada RWD
Learn Wheel Alignment Procedure
2004 Oldsmobile Bravada RWDSECTION Learn Wheel Alignment Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition to ON position, with the engine ON.
- Install the scan tool.
- Center the steering wheel.
- Lift the rear of the vehicle off the ground ensuring the rear wheels are centered.
- Go to the Learn Alignment menu choice in the scan tool. Follow the prompts on the scan tool.IMPORTANT: When prompted by the scan tool you must turn the steering wheel a full 90° to the left and a full 90° to the right and then to center and hold. If this step is not done properly then it is possible to cause a false DTC for the steering wheel position sensor.
- Press the continue button.
- Use the scan tool to clear all rear wheel steering DTC's.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.