Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 155 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)DISPOSAL PROCEDURESON-VEHICLE DEPLOYMENT
2004 Oldsmobile Bravada RWD
On-Vehicle Deployment
2004 Oldsmobile Bravada RWDSECTION On-Vehicle Deployment
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Turn ignition off, remove key and put on safety glasses. Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Cut air bag module harness connector from vehicle leaving at least 6" (152 mm) of wire at connector. Strip 0.50" (13 mm) of insulation from each connector wire lead. Cut two 15-foot (4.6 m) deployment wires from 18-gauge multi-strand wire. Strip 0.50" (13 mm) of insulation from both ends of wires. Twist wires together at one end to short. See Fig 1.
- Twist together one connector wire lead to other end of each deployment wire. Bend twisted connection flat and wrap tightly with electrical tape to insulate. Repeat this step for other connector wire lead.
- Remove all loose objects from front seat and ensure no one is in vehicle. Connect deployment harness to air bag connector. Stretch wires away from vehicle as far as possible. Separate wire ends. Connect wires to a 12-volt battery. Air bag should deploy immediately. If air bag does not deploy, go to step 6. If air bag does deploy, disconnect wires from battery. DO NOT touch metal surfaces of air bag module for at least 10 minutes due to heat generated during deployment.
- Wear gloves and safety glasses when handling deployed air bag module. Wash hands with mild soap and water. Repeat steps 2 through 4 for passenger-side air bag module.
- Carefully remove from undeployed air bag module from vehicle vehicle. See AIR BAG MODULES under REMOVAL & INSTALLATION. Temporarily store module with trim facing up. Contact manufacturer for proper disposal instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.